Has anybody used this blueprint crate motor?

[jeffahart]

Originally Posted by bigmac73

I look at it like this in the world of mass production there are going to be a few hit and misses, I just took a hit that time but it worked out. I guess I could have took the old tired 2 bolt main 350 to a local machine shop to get it redone, but who know how much i would have been in for in the end after i start adding goodies.
And the BP crate based on my earlier 90's purchased seemed like a good deal based on HP/TQ , warranty , money in pocket and time frame to get it installed. ( this was a daily driver for the most part at the time)

I have heard horror stories about the GM crate world as well, so I guess it is all about Luck of the draw.

There is no doubt about it, you just don't know till you run it. At least they stood by their warranty and took responsibility. I like to hear that. It's like you say, there is a horror story about every product out there. Hopefully I will be apart of the happy masses once I decide on a setup.

Thanks!
j