|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-31-2019, 04:32 PM
|
#1 |
|
Registered User
Join Date: Jul 2011
Location: Valley Center, Ca
Posts: 277
|
What to do with hole where Heater Control was located
Installed a heater delete on outer firewall in my 69 C10.
I would like to fill the hole where the heater controls were located on the dash but don't want weld a plate over the hole. Believe there are no aftermarket heater control delete plates and it is almost impossible to find an original part. Appreciate any thoughts about how to fill up the hole. |
|
|
| Bookmarks |
|
|
Threaded Mode