Stock location - oil pressure sender?

[focusedontheprize]

Pros: I am 2 for 2 for "Yeses"
Cons: It is based on "Is my truck wiring butchered?"

After rebuilding the carburetor, I realized I need to first fix the engine harness before going forward. I pulled the engine harness today (they had cut a bunch of the wires) and started identifying ones I need to re-wire.

One of them is the oil pressure sender. The wire was never hooked up because the sender did not have the same terminals. I am going to buy this (https://www.rockauto.com/en/moreinfo...61884&jsn=1071), but would like to know where the stock location is to install this. I have read somewhere in the rear of the intake manifold.

Can someone post a picture on theirs? Thank you.