|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-20-2019, 01:40 PM
|
#29 |
|
Registered User
Join Date: Feb 2014
Location: Dallas Texas
Posts: 61
|
Re: Steering Wheel is a half turn off after disc brake conversion
Was getting set up on the mill to machine the new locations and when I measured the locating holes on the shaft they are 17 mm (.6693"). I was thinking this was 5/8. Maybe on the older models (this front end is from a 85 suburban). I will have to order a metric end mill.
I probably should wait till I am able to remeasure the locating rivets on the cross-member. |
|
|
| Bookmarks |
|
|
Threaded Mode