The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-30-2019, 06:39 PM   #1
1bad396ss
Registered User
 
Join Date: Jul 2012
Location: STL MO
Posts: 85
Door measurements needed

I’m having some issues with one of my aftermarket doors (worst decision ever purchasing them - junk)... Regardless, I’m stuck with them at this point. The gap in the top of the door opening where the vent window and side glass passes through is wider on one door vs the other. I didn’t even bother installing the felt or rubber scraper on this door as it probably won’t touch the glass. I had read where someone cut the brace from the inner to outer skin and pinched it together and rewelded the brace/tab. It is fairly easy to get the movement needed just by squeezing by hand.

Could someone get a few measurements from the inner to outer skin in a factory door without the felts or rubber installed from front to back. Basically x distance from front corner of opening is y wide in about 3 spots. It would be greatly appreciated. I didn’t complete the other door either but it certainly isn’t as bad. Would rather get the measurements from a good factory door.
1bad396ss is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:07 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com