Trailing arm rear axel perch question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ChadW · 06-20-2019, 03:20 PM

I have a 66 c10 that is a frame off resto currently...I am slowly working to get it together. It has a cut down 10 bolt posi rearend. My queston is when putting it back together with the trailing arms in preparation for welding the axel pads on it, is there a specific "factory" width that the pads need to be set at? or do you just get them where they seem right and make sure they are equal on both sides?

06-20-2019, 03:20 PM	#1
ChadW Registered User Join Date: Jan 2018 Location: Danville, IL Posts: 160	Trailing arm rear axel perch question I have a 66 c10 that is a frame off resto currently...I am slowly working to get it together. It has a cut down 10 bolt posi rearend. My queston is when putting it back together with the trailing arms in preparation for welding the axel pads on it, is there a specific "factory" width that the pads need to be set at? or do you just get them where they seem right and make sure they are equal on both sides?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.