|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-05-2019, 06:09 PM
|
#1 |
|
Registered User
Join Date: Oct 2011
Location: bartlesville ok
Posts: 143
|
swap harness pin question
hey all,
just a question about the vss wires on green connector pins 20 and 21. which wire would a person connect to a Dakota digital 128,000 pulse generator? sen-01-128 instructions have three wires red(power for the sensor) black(ground) and white which speed input to pcm. which wire does it go to, pin 20 is low signal and pin 21 is high signal according to the pinout from lt1swap. thanks for any input. Chip |
|
|
| Bookmarks |
|
|
Threaded Mode