Working on it - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**62bagger** · 09-26-2019, 08:19 PM

I got the new engine perches for a SBC V8 yesterday. They made a big difference. I was able to get the 3 degree off level and the trans lined up. Thanks for spotting that I had the I6 mounts. The new mounts sit flat on the top of the frame rails without any shims. I just need to drill the mount points on the frame. I did cut the tubular mounts as a test and that would have worked as well but the new mounts do not need me to weld them.
Thanks Jimmy and Captainfab for the information

09-26-2019, 08:19 PM	#11
62bagger Senior Member Join Date: Mar 2016 Location: Sonora California Posts: 286	Re: Working on it I got the new engine perches for a SBC V8 yesterday. They made a big difference. I was able to get the 3 degree off level and the trans lined up. Thanks for spotting that I had the I6 mounts. The new mounts sit flat on the top of the frame rails without any shims. I just need to drill the mount points on the frame. I did cut the tubular mounts as a test and that would have worked as well but the new mounts do not need me to weld them. Thanks Jimmy and Captainfab for the information Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.