|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-23-2019, 03:49 PM
|
#1 |
|
Registered User
Join Date: Apr 2017
Location: Minneapolis, MN
Posts: 49
|
centering control arm shafts
In the process of assembling my upper and lower control arm shafts. A couple of them, I struggled to even get the threads started into the arms much less have them perfectly centered.
So my question is... is there an accepted tolerance? Say .1-.2" off? Were you able to get yours perfectly centered? That seemed to be as close as I could get with most of them. I can see this affecting the caster angle. |
|
|
| Bookmarks |
|
|
Threaded Mode