Engine swap procedures?

[Furno68C20]

I'm planning on doing taking out my exhausted 327 for a fresh rebuild and back to stock project. While the 327 is being fixed I have a 350 freshy ready for install. I'd figure to ask the community for the best way to swap engines.

I have the correct rigging for this job, except it will be done in a standard house garage with vaulted ceilings so overhead shouldn't be an issue.

I have a 700R4 trans connected the Engine. does that get removed with the engine, although i want to continue to use it.

Any advise or tips would be greatly appreciated for a smooth swap.

Also, can i use the same flywheel/bell housing with this swap.

Thank you for your responses..