Gen V L83 swap question, start and stall

[GreyGhost85]

Hey guys,
I have a question for you all. I have a gen V l83 swap with 6l80e that I having start stall issues with. However, if I disconnect negative terminal for 10 minutes or so, and reconnect it can run fine for hours. Am I not doing something correctly? I had the ecm programmed through speartech and it was remarkable turnaround time.

1. If I unplug negative cable for 5-10 minutes, it starts and runs perfectly. If I start and run it the next day without disconnecting negative terminal, it starts and fires up just fine, but does after about 15-20 seconds as if something is not registering right.

2. All grounds are tight and clean, all connections are tight and clamped. I added additional engine to ground straps and on body as well.
3. Fuel pressure is solid 75 psi. Walboro 255 pump.
4 . o2 sensors both registering voltage.
5. When stable rpm is about 650, after second start it will stall around this rpm.
6. It will start like nothing is wrong every time it does this.

Any ideas? I will try reaching out to speartech as well to see.
Posted via Mobile Device