CA K1500 front hubs - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Mr_Rich** · 05-21-2020, 03:43 AM

I have two non-ABS K-type hubs (used) that I swapped out many years ago. The reason I replaced them was preventative maintenance because I had a problem with the front axle shafts. The axle shafts were flinging grease past the seals for a long time so I replaced both sides at the time. The hubs still spin smoothly by hand and I don't detect any problem with them other than the visual view of the parts. They're GM Timken bearing hubs and I think there's still a few miles left in them if someone needs budget replacements. I was thinking maybe $100 shipped?

05-21-2020, 03:43 AM	#1
Mr_Rich Registered User Join Date: May 2006 Location: Yucaipa, Calif. Posts: 790	K1500 front hubs I have two non-ABS K-type hubs (used) that I swapped out many years ago. The reason I replaced them was preventative maintenance because I had a problem with the front axle shafts. The axle shafts were flinging grease past the seals for a long time so I replaced both sides at the time. The hubs still spin smoothly by hand and I don't detect any problem with them other than the visual view of the parts. They're GM Timken bearing hubs and I think there's still a few miles left in them if someone needs budget replacements. I was thinking maybe $100 shipped? __________________ 1989 K1500 Chev. EC Original owner; some of the aftermarket parts I've installed are Borla headers, Hypertech chip, Edelbrock water pump, and a Stillen rear disc brake conversion kit. 2009 Hummer H3T 3.7L 5M (sold) 1997 K2500 Chev. EC 7.4L/ 4L80E 2018 Dodge Ram 2500 HD R/C



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.