![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Sep 2010
Location: Goleta, CA
Posts: 8
|
Removing coil springs (front end is already out)
Looking for a little wisdom here. . . .
I have the front suspension removed from 70 C10 and need to remove the coil springs in order to disassemble and completely restore. (In the future, I’ll certainly be removing the springs the easy way with a jack while the suspension is still in the truck. But for now, this is not an option.) I've come up with the following four options. None seem great. Hoping someone's done this and can point me in the right direction. 1) Use an internal spring compressor. This sounds straightforward, but finding a compressor that works is the problem. All I've found are larger than the 2” hole in the lower control arm and won’t work. If someone could please reply with the make and model of a compressor that has worked for them under these circumstances, I’d be very grateful. 2) Rig-up a system using ratcheting tie-down straps and a floor jack to release the tension on the LCA, detach the LCA and slowly release the spring. Sounds super risky. If anyone’s actually done this and could reply with a picture or explanation, that would be very helpful. 3) Cut the springs with a torch. Sounds good. Since I’m not going to be using the springs again, destroying them is not an issue. My concern is whether the heat from the torch will be enough to reduce the energy in the stored spring when it’s cut loose. Has anyone done this? How did it go? 4) Fabricate a spring compressor using a threaded rod and steel plate. Anyone done this? If so, could you send a picture or explain how you did it. Thanks in advance for any wisdom you can send my way. |
![]() |
![]() |
Bookmarks |
|
|