Engine Harness Question

[robber grin]

I'm sure this will seem painfully obvious to someone (at least I'm hoping it will)...

Last September I pulled my 283 (with pertronix distributor / coil) because the old small mouse was TIRED - life happened - now I'm trying to finish up a "simple" 350 (OEM HEI) install nearly a year later (life).

The picture is my engine harness (from Classic Parts) that worked fine for the first install but I (am simple and) have lost all recollection of the green wire's purpose - I think it would have been for + coil for the old points set up before the conversion (and I think I still connected it after Pertronix Conversion)

So can someone just have mercy and help me verify and remember before I make a mistake?

Thank you for your consideration.

Stay well and blessed.