12-19-2020, 07:41 PM | #1 |
Senior Member
Join Date: Aug 2016
Location: Loris South Carolina
Posts: 428
|
drive shaft length
ok so I have a 350 that I have most of the parts to build and I am going to put it in my truck in place of the 250 I6, for now I am retaining the Saginaw 3 speed trans but am eventually going to put a 4 speed behind it. figured I could save up to get a good transmission once the truck is on the road and later on I could put a gearvendors over/underdrive unit in the truck. my question though is when the 350 gets bolted into the truck will I need to increase the length of my driveshaft or does the 350 sit far enough back that its not an issue? any help would be greatly appreciated.
thanks |
Bookmarks |
|
|