|
02-09-2021, 04:17 PM
|
#1 |
|
Almost Satisfied
 
Join Date: Mar 2002
Location: Springfield, MO
Posts: 2,932
|
Horn Help
I am using a new AAW harness and dual Hella horns with a Billet Specialties wheel on a stock tilt column.
I've tested the horns right from the battery. They work. I put the green plastic piece with the copper on the column first, the spring, and then the wheel. Connected the yellow wire to the horn cap and the ground. No horn. Do I need more pieces other than the green plastic piece between the column and the wheel? I did notice the relay was very warm so I pulled it out until I can figure out what I am doing wrong. I have all the factory original pieces, but from reading the Billet Specialties instructions I only need to use the green plastic piece that has the copper ring on it. Any help is appreciated.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far." |
|
|
| Bookmarks |
|
|
Threaded Mode