Cranks on run and crank/gauge question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

dman1982 · 03-10-2021, 06:53 PM

At it again, I pulled my old harness and putting in a new bp automotive harness, I was hooking up the starter and solenoid wires, now it cranks in the run and crank position. Has anyone else encountered this problem? I did have a issue with the neutral safety switch before. I havnt fully wired up the gauges and inside of my cab. This is kicking my butt.

Second question
I just bought a autometer 7004 lcd gauge cluster, I was running autometer electric gauges before, are those sending units still the same?

03-10-2021, 06:53 PM	#1
dman1982 Registered User Join Date: Jul 2010 Location: jacksonville nc Posts: 1,229	Cranks on run and crank/gauge question At it again, I pulled my old harness and putting in a new bp automotive harness, I was hooking up the starter and solenoid wires, now it cranks in the run and crank position. Has anyone else encountered this problem? I did have a issue with the neutral safety switch before. I havnt fully wired up the gauges and inside of my cab. This is kicking my butt. Second question I just bought a autometer 7004 lcd gauge cluster, I was running autometer electric gauges before, are those sending units still the same? __________________ Sgt Dennis Heineman USMC Aviation Ordnance I.Y.A.O.Y.A.S 2001-Present 84 K10 2000 trans am ws6 2011 nissan altima 2009 Troy Built with a 42 Inch Deck My LS Swap http://67-72chevytrucks.com/vboard/s...=1#post6559371



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.