Re-using a 500 mile clutch kit on a resurfaced flywheel?

[64stpside]

Hey guys,
Got the old 305 pulled out today and finally got to check to see if the stk pressure plate would bolt to the flywheel that goes on the vortec 350 I'm putting in.
In an earlier post I was asking if anyone knew if the stk pressure plate would bolt to the vortec flywheel as the vortec used a 12 in disc and didn't know if
the vortec's pressure plate had a wider mounting position. My old pressure plate will bolt up perfectly.

My next question is, the clutch kit and flywheel were purchased new when doing the s10 T5 conversion and only have 500-600 miles on them now.
Can I reuse my old clutch disc and pressure plate with the resurfaced vortec flywheel....even if the mileage is really low on the clutch kit or has the clutch disc
already developed a wear pattern that will cause clutch chatter no matter if the flywheel is resurfaced or not?