![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#21 |
Registered User
Join Date: May 2011
Location: Anderson SC
Posts: 3,890
|
Re: '88 F*rd Festiva Autocross/Track/Daily Driver Build
Got a bit more done to the new red '91. The AC wasn't working when I got it, a tube on the condenser had broken, and one on the txv was also split. Since this was an aftermarket AC system I had to figure out each component myself, no part numbers to go by.
![]() I pulled the evaporator box from under the dash and cleaned/flushed the evaporator and cleaned up the tubes and connections to ensure a better seal at the orings. Also removed the old foam and glued new foam in place. ![]() ![]() ![]() ![]() ![]() ![]() Cleaned what I could reach while the evap housing was out. ![]() ![]() I used a new universal 12x24" parallel flow condenser, drier, txv, tensioner bearing, belt, and all new o-rings to get the system back together. The used components were flushed so I could use PAG oil and R134a. The tvx and thermostat in the evap housing need adjusting to get the temps a bit lower but its working fine other than kicking off when vent temps get down to about 46 degrees. ![]() I pulled the Sport seats out of storage to begin detailing them. ![]() ![]() ![]() ![]() The vinyl cleaned up great with a magic eraser and 303 Protectant. I soaked the fabric with cleaner, scrubbed it, then used a wet/dry vac to pull the stains out. A couple of rounds of that had the fabric looking nearly new. The plastic side trim was cleaned and sprayed with SM Arnold plastic/vinyl dye. ![]() ![]() ![]()
__________________
Project Goldilocks '66 C10 Short Fleet BBW Build '65 C10 Highly Detailed Stock Restoration Thread '78 Camaro Targa Roof Build '55 International Metal/Body/Paint Work '66 F100 Full Rotisserie Restoration '40 Packard 120 Convertible Coupe Restoration How To Restore and Detail an Original Gauge Cluster How To Detail Sand Body Panels, Edges, Corners, Etc |
![]() |
![]() |
Bookmarks |
|
|