Could someone with a dyno program help me out here - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mikep · 06-10-2002, 05:23 PM

I'm trying to figure out what rear end gears to get here and I'd like some help if possible by someone with a dyno program. I'm trying to figure out where my peak torque and HP are.

My engine is a 350 chevrolet . Its .030" over . I have a .030" head gasket, zero decked, 1/8" domed pistons,

72CC chamber 200 cc intake port world product sportsman II heads which gives me about 10.2:1 compression. 2.02 inatke valves and 1.6 exhaust

The cam specs are .494" lift intake and exhaust . 232 degrees intake duration 234 exhaust on 108 degree centers. Roller tip steel rockers.

Air Gap RPM Intake. port matched

800 CFM edelbrock EPS carburetor

1 1/2 primary headers with 3 inch mufflers

HEI with MSD module

Need anything else? Any help would be appreciated

06-10-2002, 05:23 PM	#1
mikep Used to have a truck Join Date: May 2002 Location: port orchard WA Posts: 1,552	Could someone with a dyno program help me out here I'm trying to figure out what rear end gears to get here and I'd like some help if possible by someone with a dyno program. I'm trying to figure out where my peak torque and HP are. My engine is a 350 chevrolet . Its .030" over . I have a .030" head gasket, zero decked, 1/8" domed pistons, 72CC chamber 200 cc intake port world product sportsman II heads which gives me about 10.2:1 compression. 2.02 inatke valves and 1.6 exhaust The cam specs are .494" lift intake and exhaust . 232 degrees intake duration 234 exhaust on 108 degree centers. Roller tip steel rockers. Air Gap RPM Intake. port matched 800 CFM edelbrock EPS carburetor 1 1/2 primary headers with 3 inch mufflers HEI with MSD module Need anything else? Any help would be appreciated __________________ No truck :-(



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.