Won't go into gear....oh no???

[ellisjay2]

Done with engine swap, now tranny won't go into gear. I made sure that converter was fully seated before bolted block up. I've pulled tranny cooler line and no fluid while running, so yeah either pump has gone bad or somehow converter slide out. But I cautiously triple checked converter. And from what I see and took a pic of it couldn't go back any further without contacting the grooves of the tranny. And if the pump did just go bad from sitting for a few years then it is what it is, but I'm not ready to cancel it out just yet. Other than pulling tranny which I'm ready to do, what else can I check or inspect before I pull it out, th 350.... The new block I dropped in is a 70s block and came with flywheel attached. My old block was an 80s block but I left that flywheel out, I didn't see a difference comparing the two before dropping in.