Boyds Welding Fuel Tank - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Afirehawk1 · 12-21-2021, 09:58 PM

I have this tank installed on my 66.
I am confused on the the 1/2 inch NPT vent. This is the rollover vent I think.
The other port 5/8 inch is for a vacuum canister.

I am installing a remote fill on the bed fender. See photo what i was planning. So should my remote fill have a port added then run a hose from that to the 1/2 inch brass fitting??

Regarding the 5/8 port; i dont plan on running a vacuum canister unless i have to; so just plug that port??
Posted via Mobile Device

12-21-2021, 09:58 PM	#1
Afirehawk1 Registered User Join Date: Feb 2016 Location: Valrico, Florida Posts: 661	Boyds Welding Fuel Tank I have this tank installed on my 66. I am confused on the the 1/2 inch NPT vent. This is the rollover vent I think. The other port 5/8 inch is for a vacuum canister. I am installing a remote fill on the bed fender. See photo what i was planning. So should my remote fill have a port added then run a hose from that to the 1/2 inch brass fitting?? Regarding the 5/8 port; i dont plan on running a vacuum canister unless i have to; so just plug that port?? Posted via Mobile Device Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.