|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-09-2022, 12:29 AM
|
#26 |
|
Registered User
 Join Date: Feb 2020
Location: Victoria BC
Posts: 20
|
Re: Time for a Canadian build thread
OK, I made an attempt at folding over the rear corner of the shortened box side. First step is to trace the box corner and make a 1/4" plate form. Second step is to draw your bend line and tack the form into the bed. Then start lightly tapping the edge over. Lots of small light taps and try to bring it over evenly tapping the high spots.
|
|
|
| Bookmarks |
|
|
Threaded Mode