Anybody put a sway bar on CPP Tubular Control Arms?

[BrentBTK]

So, When I bought the truck, I went a little crazy and ordered a bunch of stuff at once, and the last of it is finally trickling in 3 months later. I installed CPP tubular control arms a while ago, and my sway bar kit just showed up. I went to install it, and it appears to be a few inches too wide. When I install one end of the bar into the lower control arm mount, the other side is nowhere close to lining up with the other mount. I'm wondering if the mounting point on these lower arms is different than what would have been original. I've been looking at other sway bars online and am not really seeing any mention on width difference, but it absolutely will not fit. Has anyone used these arms and a sway bar?