|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-25-2022, 06:20 AM
|
#1 |
|
Senior Member
 
Join Date: Jun 2007
Location: Pine Ridge Florida
Posts: 4,134
|
WTB AC/heat controller bulb sockets
I would like to purchase two or four if possible light sockets with about a foot of gray wire on them for the heater and AC control display light. I have a hard time getting those sockets in when the controller is in place. I would like to make a small little harness with the two sockets and a connector so I can have it pre-installed and just have to connect a connector. Since I have two blazers I would really like to do this to both of them.
Thanks Mark
__________________
Click on my Not really a build thread, yet NOT SO RUST FREE RUST FREE BLAZER LS ENGINE SWAP INFORMATION THREAD BOLT RESTORATIONS 4l60 to an NP205 |
|
|
| Bookmarks |
|
|
Threaded Mode