70 C10 stance sitting uneven

[andymiller]

Been chasing this one all summer.

History of truck, was a $1800 farm truck, 1970 2wd C10 longbed. Nothing fancy, 307, th350. Have done a bunch of work, shortened frame, shortened bed to short bed. Rear end gears, lowered, 327, and now a 412. Cab corners, rockers. Poly body mounts, shocks, front disk conversion, etc.. alot of work over the past 3 yrs.

Was lowered by cutting one coil, gave me about 2.5" in the front and new rear springs gave me 4" drop. It was sitting level.

My issue since May 2022, the front left sits an inch higher, and right rear sits low an inch lower.
I had changed to front disk and poly body mounts then the stance changed. Have checked shocks, changed front springs to lower 3" spring, rear springs still measure equal. Pulled panhard bar, thought it was loaded up on one side.
Loosened all body mounts, and retighted, thought it was in a bind.

Any ideas of what to check next?

Kinda running out of ideas.

Thanks