Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
08-12-2023, 05:04 PM | #1 |
Mr. Cheyenne
Join Date: Jun 2020
Location: Kyle, Texas
Posts: 1,687
|
Question on Replacing Cab/Radiator Mounts
I got in my full body mount kit from GMC Paul's, which included the bed bolts and pads for the bed. All in one kit in different bags, no descriptions, no part numbers, so guessing needing to be done.
The bed/pads were easy, put them to the side - may never use them. Front Radiator mounts pretty easy too as I was able to build up two mounts from another bag (had carriage bolts and square washers). Interesting there was no inner sleeves, I assume there should be sleeves? The last bag I seem to have some extra parts (see photo) but for sure contain the front/rear cab mounts. I wonder if the extra parts are radiator mounts but there were no bolts... but there are sleeves. I have done the driver sider, photos of each attached. Cab was a snap. The radiator not so much. That nub took me forever and it only came off after I heated it up with my hobby torch until it was super hot.
__________________
Richard '72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT SBC 350 | TH350 | LWB | AC | Buddy Seats Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim Last edited by Rich72C10; 08-12-2023 at 07:43 PM. |
Bookmarks |
|
|