Correct Motor Mounts 1968 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**damnyankee36** · 12-24-2023, 12:40 PM

Having an issue with some new motor mounts. The power steering bracket attaches to the lower stud as shown below. The new mount's bolt is surrounded by rubber and steel which is now interfering with the bracket.

I've looking all over and I haven't found one mount that is like what I assume was the original one.

I did a search and didn't find anyone else with a similar problem.

I suppose I could try to install bracket under the motor mount or even trim the rubber and structure around the bottom hole,but. I'd rather not do that.

Any ideas?

12-24-2023, 12:40 PM	#1
damnyankee36 Senior Member Join Date: Sep 2002 Location: Alamogordo, NM Posts: 724	Correct Motor Mounts 1968 Having an issue with some new motor mounts. The power steering bracket attaches to the lower stud as shown below. The new mount's bolt is surrounded by rubber and steel which is now interfering with the bracket. I've looking all over and I haven't found one mount that is like what I assume was the original one. I did a search and didn't find anyone else with a similar problem. I suppose I could try to install bracket under the motor mount or even trim the rubber and structure around the bottom hole,but. I'd rather not do that. Any ideas? Attached Images __________________ 1966 C10 Custom Cab Restomod (Sold) 1969 Camaro Z/28 (Keeper) Current Build: 1968 C10 (Semi-Factory Restoration) 1983 Camaro Z/28 (Next in line, Keeper) 1951 3100 (2nd in line)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.