GA WTB: Clutch Setup - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**cwcarpenter98** · 12-26-2023, 11:26 AM

I've decided I want to swap my 81 over to a manual, so I need the clutch parts to make that happen.

I'm leaning towards using mechanical linkage instead of hydraulic because I already have a bellhousing that uses the mechanical linkage.

I only have that bellhousing with a clutch fork, so I would need everything else.
Pedals, linkage rods, z bar, and piece that mounts z bar to the frame.

I wouldn't be against a hydraulic setup if the price is reasonable and it comes with the bellhousing that I would need too.

Probably going to have to be something located within a couple hours of Canton, GA since the parts a fairly large.

12-26-2023, 11:26 AM	#1
cwcarpenter98 Senior Member Join Date: Jan 2018 Location: Hickory Flat, GA Posts: 4,491	WTB: Clutch Setup I've decided I want to swap my 81 over to a manual, so I need the clutch parts to make that happen. I'm leaning towards using mechanical linkage instead of hydraulic because I already have a bellhousing that uses the mechanical linkage. I only have that bellhousing with a clutch fork, so I would need everything else. Pedals, linkage rods, z bar, and piece that mounts z bar to the frame. I wouldn't be against a hydraulic setup if the price is reasonable and it comes with the bellhousing that I would need too. Probably going to have to be something located within a couple hours of Canton, GA since the parts a fairly large. __________________ Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.