NP205 floor clearance - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Yukon Jack** · 09-19-2004, 11:17 AM

I just swapped in an NP205 into my 70 K5 - the prior owner said it had a Dana 20. I have all new rubber body mounts and I am using polyurethane transfer case mounts, the ones that are used to attach the adapter to the crossmember.

The NP205 is just barely touching the bottom of the K5's floor. I have not been able to torque down the bolts going through the crossmember to the adapter but I doubt that will pull the NP205 down much. I need to move the crossmember back approximately 3/8" to make it so I can bolt the adapter to the crossmember.

What kind of clearance do you all have between your floor and your transfer case?

09-19-2004, 11:17 AM	#1
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,689	NP205 floor clearance I just swapped in an NP205 into my 70 K5 - the prior owner said it had a Dana 20. I have all new rubber body mounts and I am using polyurethane transfer case mounts, the ones that are used to attach the adapter to the crossmember. The NP205 is just barely touching the bottom of the K5's floor. I have not been able to torque down the bolts going through the crossmember to the adapter but I doubt that will pull the NP205 down much. I need to move the crossmember back approximately 3/8" to make it so I can bolt the adapter to the crossmember. What kind of clearance do you all have between your floor and your transfer case? __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.