PB Booster bracket question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

HeavyD · 10-28-2004, 03:13 PM

Hi. I just received my used PB booster assembly and have a question about the brackets on the booster. Attached on the driver side bold/nut that hold on the master cylinder is 2 support brackets, one short and bending toward the front, and one long going to the rear of the truck. What are these brackets for? I have seen other trucks boosters and they did not have these that I can remember. It is going on a 1970 GMC 1/2 ton 2wd. I would post pics if I could get something besides a red X to appear where the pic should be.

Thanks everyone.

10-28-2004, 03:13 PM	#1
HeavyD Senior Member Join Date: Sep 2004 Location: Wakaw, Sask, Canada Posts: 3,180	PB Booster bracket question Hi. I just received my used PB booster assembly and have a question about the brackets on the booster. Attached on the driver side bold/nut that hold on the master cylinder is 2 support brackets, one short and bending toward the front, and one long going to the rear of the truck. What are these brackets for? I have seen other trucks boosters and they did not have these that I can remember. It is going on a 1970 GMC 1/2 ton 2wd. I would post pics if I could get something besides a red X to appear where the pic should be. Thanks everyone. __________________ "You can take the man out of PA, but you can't take PA out of the man"



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.