Center bearing mounting - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Ricks69 · 11-27-2004, 10:35 PM

Hi,
In my haste to get my new project together I purchased a used tranny and driveline. Now that I have installed it in my 69 longbed, I have found that the tranny is the longer tailshaft version and my original driveline is now too long.
I do have a driveline from a later truck and it does seem to be the right length however my center bearing mount is the early in-line type and the later one has the more traditional straddle type mount. So, my question is....is there an easy way to adapt, weld, fabricate a mount for the later center bearing/driveline without changing out the crossmember?
Or am I going to have to shorten the existing driveline?
Thanks
Rick

FRENCHBLUE72 · 11-28-2004, 01:04 AM

I would just shorten the driveshaft and call the problem solved..

11-27-2004, 10:35 PM	#1
Ricks69 Registered User Join Date: Oct 2004 Location: San Diego Posts: 13	Center bearing mounting Hi, In my haste to get my new project together I purchased a used tranny and driveline. Now that I have installed it in my 69 longbed, I have found that the tranny is the longer tailshaft version and my original driveline is now too long. I do have a driveline from a later truck and it does seem to be the right length however my center bearing mount is the early in-line type and the later one has the more traditional straddle type mount. So, my question is....is there an easy way to adapt, weld, fabricate a mount for the later center bearing/driveline without changing out the crossmember? Or am I going to have to shorten the existing driveline? Thanks Rick __________________ Rick 69 Longbed Project 57 Chevy 406 Four Speed

11-28-2004, 01:04 AM	#2
FRENCHBLUE72 PROJECT 7DEUCE Join Date: Dec 2002 Location: GRANTS PASS OR Posts: 21,606	I would just shorten the driveshaft and call the problem solved.. __________________ GO BIG GREEN GO DUCKS MEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.