Turn signal switch non/tilt - The 1947 - Present Chevrolet & GMC Truck Message Board Network

sealw98 · 12-13-2004, 04:25 PM

Are these hard to put in or should you hire someone for this job? I know you remove the steering wheel and the switch ,but what about the long wire how do you get that back down in the column?

JimKshortstep4x4 · 12-13-2004, 08:48 PM

The turn signal switches are not too difficult to change. The service manual has some pretty good instructions in it and if you like, PM a fax number to me and I will fax them to you.

The wires are a not that hard to feed through with the wire cover and connector removed.

Jim

12-13-2004, 04:25 PM	#1
sealw98 Registered User Join Date: Sep 2003 Location: Detroit/Area Posts: 27	Turn signal switch non/tilt Are these hard to put in or should you hire someone for this job? I know you remove the steering wheel and the switch ,but what about the long wire how do you get that back down in the column?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-13-2004, 08:48 PM	#2
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	The turn signal switches are not too difficult to change. The service manual has some pretty good instructions in it and if you like, PM a fax number to me and I will fax them to you. The wires are a not that hard to feed through with the wire cover and connector removed. Jim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.