Oil fill tube question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

chipflyer · 01-30-2005, 10:02 PM

I have a pair of chrome valve covers that I want to replace with the correct stock 71 350 covers. I have the oil fill tube but I need the grommet that goes in the valve cover that would replce the stock cap, I think. Anyone got the GM part number or know where I can order one of these? It is supposed to go into the hole and replace the stock cap on the drivers side, correct? The tube is 1 inch in diameter and the hole at the back of the valve cover is around 1 1/4.
Thanks

**southern parts** · 01-30-2005, 10:41 PM

You can get them in the help section of just about any auto parts store.
Woody

01-30-2005, 10:02 PM	#1
chipflyer Registered User Join Date: May 2004 Location: Topeka, Ks Posts: 2,293	Oil fill tube question I have a pair of chrome valve covers that I want to replace with the correct stock 71 350 covers. I have the oil fill tube but I need the grommet that goes in the valve cover that would replce the stock cap, I think. Anyone got the GM part number or know where I can order one of these? It is supposed to go into the hole and replace the stock cap on the drivers side, correct? The tube is 1 inch in diameter and the hole at the back of the valve cover is around 1 1/4. Thanks __________________ I'm not a pessimist, I'm just optimistic that bad things are going to happen. 1971 Cheyenne Super K10 - tilt, cruise, air, am/fm, tow hooks, factory buckets! 1986 Jeep J10 pickup, - 5.3L Vortec with 4L60e and NP241.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-30-2005, 10:41 PM	#2
southern parts Senior Member Join Date: Apr 2003 Location: Elberton Ga. Posts: 3,472	You can get them in the help section of just about any auto parts store. Woody



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.