![]() |
|
![]() |
#1 |
Professional Grade
Join Date: May 2003
Location: Fort McMurray, Alberta
Posts: 7,915
|
With some of the really big trucks, its almost easier to shift without the clutch than with, lol
So long as you are just able to slip the shifter in (aka, no forcing it) you arn't likely to hurt that rock crusher tranny too badly ![]() ![]()
__________________
1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap) |
![]() |
![]() |
![]() |
#2 |
Check out GMTrucks.org
Join Date: Sep 2003
Location: Boise, Id
Posts: 284
|
When I was a kid I drove this 75ish datsun pickup that the throw out was going out on. You had enough clutch disengagement to get it into gear right before you took off at a stop sign. Anyway, you had to shift up and down without a clutch. If you get the rpms matched up and don't force it if it is not ready to go, I don't think you are doing much damage to your tranny. We drove that truck like that for years.
Shifting up without using the clutch is infinitely easier than down shifting... |
![]() |
![]() |
![]() |
#3 |
Crazy
Join Date: Apr 2005
Location: Emmaus, Pa
Posts: 203
|
As long as you aren't grinding any gears, its not doing anything bad to your truck at all. Once I was out on a trip going fourwheeling, and I came to a stop light and pushed in the clutch and wham stuck to the floor. So I shut off the truck and rolled over to the side of the road, only to notice that my clutch linkage had vibrated and fell out. So I called my dad and asked him, and he said just come to a stop light and shut the truck off, then put it in creeper gear and start it up when the light goes green, will be a little jerky but wouldnt hurt anything, then just shift the gears normally using the RPM. I drove the rest of the way (another 40 miles) then back home later in the day, ( 140 miles) and it was easy as pie and didnt hurt anything. Sometimes I shift that way now, just becasue i am too lazy to push in the clutch, works both ways upshifting and downshifting. And yea, my buddy that drives semi truck only uses the clutch to pull out, and never again till he stops. Won't hurt a thing, and if you keep practicing, you will be ready if your clutch linkage falls out.
![]()
__________________
77 SB Stepside in a bunch of pieces scattered around the garage. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|