Looking for a pair of good backing plates - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Maxwell007 · 09-08-2005, 01:24 PM

Need a pair of backing plates for my 72 3/4T with a Dana 60 rear. Doing a brake job and the old ones are badly grooved. I can weld them up and grind the pads flat but would prefer new plates or at least ones better than what I have.
Thanks in advance for any responses.

**raggedjim** · 09-08-2005, 05:01 PM

Maxwell, when I was looking for these I ended up welding and grinding, good ones are hard to come by.

Good luck, Rg

09-08-2005, 01:24 PM	#1
Maxwell007 Registered User Join Date: Apr 2005 Location: Southern California Posts: 14	Looking for a pair of good backing plates Need a pair of backing plates for my 72 3/4T with a Dana 60 rear. Doing a brake job and the old ones are badly grooved. I can weld them up and grind the pads flat but would prefer new plates or at least ones better than what I have. Thanks in advance for any responses.

09-08-2005, 05:01 PM	#2
raggedjim Senior Member Join Date: Jun 2002 Location: Murray, Kentucky Posts: 3,477	Maxwell, when I was looking for these I ended up welding and grinding, good ones are hard to come by. Good luck, Rg __________________ Roger '68 Short step - https://67-72chevytrucks.com/vboard/...d.php?t=849675 '69 ('70?) 2wd Blazer '70 GMC Jimmy 2wd '73 Firebird - https://67-72chevytrucks.com/vboard/...d.php?t=853203

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.