|
10-14-2005, 08:13 PM
|
#1 |
|
Registered User
Join Date: Jan 2002
Location: WATAUGA,TX
Posts: 675
|
A-arms
I am going to have my upper and lower a-arms powder coated and was wondering if there is a way to get the lower ball joints out besides pressing them out. I really dont care if I destroy the ball joints as they will be replaced. Also am I going to have to grind out the powder coating to press in the new ones.
__________________
72 2wd 307/AT/AC/TILT WHEEL 78 JIMMY HIGH SIERRA |
|
|
|
10-14-2005, 08:16 PM
|
#2 |
|
18 Till I Die
Join Date: Mar 2005
Location: Alberta, Canada
Posts: 1,522
|
If its still on the truck, pull the spring out, put a jackstand under the a-arm next to the ball-joint and about 3-4 good wacks with a hammer.
__________________
2011 GMC Acadia 1969 GMC BBC LS7 2007 GMC Crew Duramax 1987 Camaro Iroc 350 Tuned Port Injection 42000Km 1987 Chevrolet Silverado 350 TBI 1987 Chevrolet Silverado 350 TBI(yes 2) Take me drunk, I'm too home... 
|
|
|
|
|
10-14-2005, 08:31 PM
|
#3 |
|
Senior Member
 Join Date: Mar 2001
Location: Cedar Park, TX
Posts: 686
|
You can "pound" them out...but take 'em to a shop and press them out. Several autoparts places will loan you a tool to press them out, makes for a much easier job and no damage. Stick with MOOG and/or TRW for replacements, alot of places sell cheaper stuff (and there is a reason it cheaper...junk)
__________________
71 Chevy C-10 SWB Fleetside RamJet-350/4L60e & Compushift/3.73Posi See it at www.prismnet.com/~grzanich |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
