|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-20-2005, 10:48 AM
|
#1 |
|
Registered User
Join Date: Jul 2005
Location: downingtown pa
Posts: 62
|
Where Ti Find Hump For Bigger Trans
I Need To Know Where I Can Find This Hump People Told Me About To Make My T5 Fit In My 68 And Does It Weld In Or Bolt In And How Much Do I Need To Cut Out Of The Floor
|
|
|
|
10-20-2005, 10:58 AM
|
#2 |
|
Saving 1 truck at a time!
Join Date: Aug 2001
Location: Kent, WA
Posts: 6,465
|
Re: Where Ti Find Hump For Bigger Trans
Check the parts board for a "high hump" tranny cover. You will have to cut the old low hump cover out ane either screw, weld or rivet the new high hump into place. The high hump came with big block trucks and with 4x4 trucks I believe. Someone will correct me if I am wrong.
__________________
'68 C20 Longhorn 50th Anniversary 400/TH400 '68 C20 Longhorn 50th Anniversary 468/TH400w/buckets '72 C20 Halfhorn (Longhorn w/o cab and front clip) '69 Flxible Cruiser (look up ugly in the dictionary) |
|
|
|
|
10-20-2005, 12:03 PM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Where Ti Find Hump For Bigger Trans
it's easy enough to take a piece of sheetmetal and make one //it's called fabrication
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
10-20-2005, 03:16 PM
|
#4 |
|
DON'T TREAD ON ME
 
Join Date: May 2005
Location: Crosby County, TX
Posts: 989
|
Re: Where Ti Find Hump For Bigger Trans
Both 4wd and 2wd trucks with the top loader 4 speed (SM-465) have the high hump transmission tunnel.
__________________
Old Yeller |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
