![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Used to have a truck
Join Date: May 2002
Location: port orchard WA
Posts: 1,552
|
Shifter renew question
I just pulled the shifter handle out. I'd have to say that once I figured out that only the outer collar has to turn it was a snap to take out. Anyway there is a roll pin at the end of the shaft. The hole that the roll pin passes through looks sloppy ( the outer collar ). Should that be a tight fit? Shoud I ream it out for a larger OD pin. will that tighten my shifter play up?
__________________
No truck :-( |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Apr 2002
Location: Help! I'm in an office park with its own network of freeways!
Posts: 470
|
That fit should be tight. At least mine is.
Go ahead and put a larger roll pin in. I don't know how much play--if any--it'll take out, but it's worth a shot.
__________________
'67 C20--427 tall deck/SM420, 4.10 HO52 (Michigan has not been kind to the Old Man) '95 Caprice--355 LT1/T56/3.42 8.5" 10-bolt (daily driver, almost 300k on the chassis) '07 Outback--wife's car. 125k & counting. No head gasket or transmission issues yet. *fingers crossed* |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|