![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Aug 2005
Location: tulsa OK
Posts: 3,070
|
drop spindles conformation
can someone please confirm that these will indeed fit a 68 c10 ball joint/ tie rod ends and it also is a 2" drop.. i searched but to no luck thanks
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Aug 2005
Location: tulsa OK
Posts: 3,070
|
Re: drop spindles conformation
guess this would help
http://cgi.ebay.com/ebaymotors/ws/eB...RK%3AMEWN%3AIT |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Dec 1999
Location: TN/VA
Posts: 6,388
|
Re: drop spindles conformation
If I was going to give that for them I would go ahead and buy new.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Aug 2005
Location: tulsa OK
Posts: 3,070
|
Re: drop spindles conformation
ive been lookin for awhile now for some 2" drop spindles, not 2.5 or 3" and had no luck. i know for about 40$ more + shipping i could of bought a new set of 2.5" spindles.
Tim could you send a pic of this, DG009 69-72 Complete Dash Gauge cluster, to donhulse@sbcglobal.net |
![]() |
![]() |
![]() |
#5 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: drop spindles conformation
I'm pretty sure that's a 3 inch drop spindle. BellTech part number is 3800 in the picture. The "3" is the 3 inch drop. Example, my Blazer has 3 inch drop Belltech spindles, part number 3100.
I looked everywhere on the internet though and can't find the 3800 part number to confirm. All I can find is the 3120, which fits 71-72 only. I can't find any Belltech application that's older than 71.
__________________
I'm on the Instagram- @Gearhead_Kevin Last edited by Tx Firefighter; 01-01-2006 at 04:20 PM. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|