|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-01-2006, 05:21 PM
|
#1 |
|
GM ONLY BABY!!!
Join Date: Oct 2003
Location: Fort Wayne, IN.
Posts: 1,998
|
Doing front end rebuild, will I need any bushings?
Are there any rubber bushings in the A arms of a 72 GMC 1500? I am going to purchase ball joints, tie rods, idler, pitman, anything else I will need in order to rebuild front end?
__________________
2 wrongs don't make a right, but 3 lefts do. 66 Chevelle Malibu 406ci, 573hp, 10.99@121mph 96 Chevy Silverado Z71 72 GMC 1500 Super Custom LS 6.0/4L65 on airride   http://www.cardomain.com/ride/707879...mc-c-k-pick-up |
|
|
|
01-01-2006, 05:49 PM
|
#2 |
|
Senior Member
 
Join Date: Feb 2004
Location: Williamsburg, Ohio
Posts: 1,798
|
Re: Doing front end rebuild, will I need any bushings?
nice avatar -- as soon as I can stop looking at it I will type something useful. 72 has the threaded bushings and caps --- when you unleash the top ball joint --you can check for wear on the upper A-arm bushings Usually the top bushing go before the bottoms. Make sure top and bottom both take grease even if they do not feel worn.. If properly maintained--greasing with oil change, they never wear out.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
