Back of cab sheet metal panel even made? - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

FirstGen · 01-17-2006, 12:43 PM

Insurance has written me an estimate to fix the damage to my cab by replacing the entire back of it with a replacement panel. I was wondering if anyone knows for sure if this is or isn't actually produced? I could not find this anywhere online. I am talking about the metal basically from the rear window down to the bottom of the cab and the entire width of back of the cab.
I already checked Shermans with no luck. I was hoping that this was not produced forcing them to replace the entire cab...
Thanks for any help.

01-17-2006, 12:43 PM	#1
FirstGen Just Don't Stop! Join Date: Feb 2004 Location: Dallas Posts: 1,239	Back of cab sheet metal panel even made? Insurance has written me an estimate to fix the damage to my cab by replacing the entire back of it with a replacement panel. I was wondering if anyone knows for sure if this is or isn't actually produced? I could not find this anywhere online. I am talking about the metal basically from the rear window down to the bottom of the cab and the entire width of back of the cab. I already checked Shermans with no luck. I was hoping that this was not produced forcing them to replace the entire cab... Thanks for any help. __________________ 1968 C10 build in process TT LSA/6L90e/9"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.