Floor pan/Rocker replacement - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Rokcrln · 03-26-2006, 02:11 PM

Quick paste to get you started~~
As far as where to start you will need to start with removal of the rusted parts. Then order of new parts will be somthing like this.
1) floor boards (this part has the inner rocker attached)
2) Kick panel
3) "A" piller bottom if needed (they all most always need it)
4) rear half of inner rocker
5) outer rocker

That will be close from what I can see from the pick. Check out this post for simular repairs that I have done.
http://67-72chevytrucks.com/vboard/s...d.php?t=188993

Kevin
LFD Inc.

03-26-2006, 02:11 PM	#1
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Re: Floor pan/Rocker replacement Quick paste to get you started~~ As far as where to start you will need to start with removal of the rusted parts. Then order of new parts will be somthing like this. 1) floor boards (this part has the inner rocker attached) 2) Kick panel 3) "A" piller bottom if needed (they all most always need it) 4) rear half of inner rocker 5) outer rocker That will be close from what I can see from the pick. Check out this post for simular repairs that I have done. http://67-72chevytrucks.com/vboard/s...d.php?t=188993 Kevin LFD Inc.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.