![]() |
![]() |
#1 |
Senior Member
Join Date: May 2004
Location: Caldwell,Tx.
Posts: 3,648
|
Rear Cab Moulding ?
My 77 Bonanza does not have the Cab moulding since it is a sloid Mariner Blue truck and it was an option that most Bonanzas dont have . I bought a couple complete GM mouldings and want to install one on my truck . Is it something best taken to a body shop or does someone have a link to how to properly install one ? I need the measurements for the holes on the sides for sure . Would it be best to have the little T studs (welded on ) installed or is there another way to install the rear section ? Frank
__________________
Born and proudly residing in a Red State ! |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2004
Location: Caldwell,Tx.
Posts: 3,648
|
Re: Rear Cab Moulding ?
Anyone ?
__________________
Born and proudly residing in a Red State ! |
![]() |
![]() |
![]() |
#3 |
Active Member
Join Date: Feb 2004
Location: Atlanta GA
Posts: 174
|
Re: Rear Cab Moulding ?
Just a thought, but have you posted this in the paint/body section? That's where the folks who live and breathe this stuff hang out
![]() And no, I'm not one of them and don't have the answer ![]() Brian |
![]() |
![]() |
![]() |
#4 |
State of Confusion!
![]() ![]() Join Date: Jul 2002
Location: Gulfport, MS USA
Posts: 46,844
|
Re: Rear Cab Moulding ?
The proper way would be to weld the studs onto the body, then add your clips and trim. I have heard of folks using sheetmetal screws (and clear RTV to seal them) to hold the clips on.
__________________
Bill 1970 Chevy Custom/10 LWB Fleetside 2010 Toyota Tacoma PreRunner SR5 Double Cab - DD Member of Louisiana Classic Truck Club (LCTC) Bill's Gallery Life isn't tied with a bow, but it's still a gift. Live simply. Love generously. Care deeply. Speak kindly. Leave the rest to God! |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Jul 2004
Location: Spanish Springs, NV
Posts: 1,171
|
![]()
The corner mouldings fit with a bolt thru spring clip. And the rear cab moulding is a screw thru nylon clip. A trip to the local boneyard with a flat and phillips screwdriver a 3/8 & 5/16 socket and a tape measure would get you the clips and mounting dimensions.
Here's a cut of what you need. ![]() Caution: The corner mouldings require a reach up behind the seat into the "B" column to access the nut on the spring clip. Good luck and send pics when done. - Dave
__________________
2003 Silverado K1500 Z71 - Arrival Blue 1973 K5 Cheyenne Blazer 350/TH350/NP203 Kids Trucks:92 K1500 Blazer 5.7/700R4 4" lift. RETIRED: 1980 Scottsdale 4x4 Founding Member: "TILT WHEEL BELLY." Club |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|