|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-30-2006, 03:03 AM
|
#1 |
|
Pickin' and a Grinin'
Join Date: May 2006
Location: Arizona
Posts: 128
|
Loose Column shift lever.
After rooting around for a while, and probably not looking at the right spot, I
would like to ask if there is a way to tighten up my shifting lever on my burb. It goes into gear just fine, but there is a lot of play in it. It is loose and flabby........ I want to replace it (in the future, but would like to find a temporary solution now) Thanks for the help... jeff Last edited by jmbstudios; 05-30-2006 at 03:08 AM. |
|
|
|
06-02-2006, 06:59 PM
|
#2 |
|
Pickin' and a Grinin'
Join Date: May 2006
Location: Arizona
Posts: 128
|
Re: Loose Column shift lever.
anyone..........anyone...............Bueller..............
By the way... It is an automatic. I migiht have mis-named the part... thanks jeff |
|
|
|
|
06-02-2006, 10:44 PM
|
#3 |
|
Registered User
 
Join Date: Aug 2005
Location: Hillsboro Oregon
Posts: 6,449
|
Re: Loose Column shift lever.
OK, let's start with the obvious. Is the pin that holds the actual lever in right? Is it worn? You probably have a little play in several places. Beyond that, check the linkage from the column to the tranny. There are several places in there that can get loose.
|
|
|
|
|
06-03-2006, 06:03 AM
|
#4 |
|
Pickin' and a Grinin'
Join Date: May 2006
Location: Arizona
Posts: 128
|
Re: Loose Column shift lever.
Thanks Mr. Fry.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
