|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-17-2006, 11:04 AM
|
#1 |
|
Next project: 1970 K10
Join Date: Feb 2004
Location: Fort Collins, Colo 80524
Posts: 6,685
|
Steering wheel/horn ring issues with van tilt
I was cleaning up the van tilt getting it ready to paint, when I thought I would try the steering wheel on to see if it fit. It doesn't. The plastic horn contact ring is too small (diameter) to fit over the shaft.
Does anyone know what horn contact ring I need to use? I have a late 80's truck steering wheel, the 4-spoke jobber. Pic of the wheel: 
__________________
Bob 1970 Chevy K10 LWB "Goldie" 350/TH350 next project!! 1981 Chevy C10 LWB 355/TH350 - My son's truck LS SWAP FORUM! Tons of LS swap info here! PLEASE CLICK HERE TO SUPPORT THE GREATEST BOARD ON THE NET! CLICK HERE FOR THE FAQ INDEX by KRUE |
|
|
|
07-17-2006, 11:08 AM
|
#2 |
|
Registered User
Join Date: Feb 2004
Location: Tacoma WA
Posts: 1,365
|
Re: Steering wheel/horn ring issues with van tilt
Check FAQ. Andy did a nice writeup on that item. Basically use the the van cancel cam on the van column. That wheel should fit just fine.
Good luck - Bob
__________________
67 C-20 LWB, tilt, speed alert, vac, 454, T400 67 C-10 SWB, factory air with more to follow |
|
|
|
|
07-17-2006, 11:11 AM
|
#3 |
|
Next project: 1970 K10
Join Date: Feb 2004
Location: Fort Collins, Colo 80524
Posts: 6,685
|
Re: Steering wheel/horn ring issues with van tilt
Cool, thanks! Found it.
Now, anyone know a part number for them? Or if AutoZone or anyone else has them?
__________________
Bob 1970 Chevy K10 LWB "Goldie" 350/TH350 next project!! 1981 Chevy C10 LWB 355/TH350 - My son's truck LS SWAP FORUM! Tons of LS swap info here! PLEASE CLICK HERE TO SUPPORT THE GREATEST BOARD ON THE NET! CLICK HERE FOR THE FAQ INDEX by KRUE Last edited by glock35ipsc; 07-17-2006 at 11:28 AM. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
