|
07-19-2006, 06:37 PM
|
#1 |
|
Registered User
Join Date: Sep 2005
Location: spokane, washington
Posts: 302
|
crossmember removal
i am getting ready to remove the front crossmember from my 80 c-10 and would like to know if i should take a few measurement first. there is a couple of the holes that look like you can shift the member back/forward so should i?
or could i just remove the member and bolt it back up with no worries. i am not going to be doing any mods to the member, i just want it out so when i coat the member i get all the way around everything. thanks steve |
|
|
|
07-19-2006, 08:30 PM
|
#2 |
|
Account Suspended
Join Date: Jun 2000
Location: over yonder
Posts: 14,270
|
Re: crossmember removal
not sure it can be reassemble more than one way, but if you are concerned about it you could always mark 1 hole on from each frame rail with a center punch
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
