|
10-19-2006, 12:49 PM
|
#1 |
|
Senior Member
Join Date: Mar 2003
Location: St robert Mo
Posts: 2,001
|
thermostat question
I am replacing my water neck and upper hose, to one of those chrome ribbed ones anyone use those you like them?
Anyway ordering from summit what is a good thermostat to get?
__________________
1968 c10 lowered 3" 4" 355/Th400 built by Hatfield racing in joplin MO |
|
|
|
10-20-2006, 02:49 PM
|
#2 |
|
chevy truck fan
Join Date: Mar 2005
Location: Gilbert, arizona 85298
Posts: 2,008
|
Re: thermostat question
well,
i did the same thing when i put my new engine in. i would highly recommend that yo u"plane" the surface of the housing before you install it!! i kept getting a leak at the housing & finally after getting info. from the board i was told to do the same thing now i have no leak. i sure did grind alot off the housing base though. i also installed the kool-flex hose on afterwards & so far seems to be working just fine. it looks good al together.. good luck! rodstored-72 |
|
|
|
|
10-20-2006, 09:00 PM
|
#3 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: thermostat question
I used to use the Mr Gasket O-ring one when i had a chevy motor, never had a single problem with the o-ring leaking, removed it every 6 months.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
