help me come up wiht a value. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Lightspeed · 11-14-2002, 01:21 AM

71 chevy, short stepside. 76k miles on body. was originally six cylinder with 3 speed on column, now has 70 LT1(un-original heads intake and carb) and a muncie four speed. engine was rebuilt about 3 years ago and has hardly any miles since. truck is pretty solid except for some pitted rust(no holes) around drip rails. also the floorboards have about a 2 inch by 4 inch rust hole on both sides. what do you guys think? im not really planning on seling it, im just curious as to whether i got ripped off in buying it.

Lightspeed · 11-14-2002, 02:03 AM

TTT, anyone have any ideas?

bad 71 chevy · 11-14-2002, 04:03 AM

no ideas but what did you do with the 3 speed and was it on the colom i would love to have the linkages if you still have them if not o well thanks and i woud say no less than 3000

Lightspeed · 11-14-2002, 06:14 AM

no don't have the linkage. i paid 2600 for her, so i guess i did ok.

11-14-2002, 01:21 AM	#1
Lightspeed Registered User Join Date: Oct 2002 Location: Virginia Posts: 226	help me come up wiht a value. 71 chevy, short stepside. 76k miles on body. was originally six cylinder with 3 speed on column, now has 70 LT1(un-original heads intake and carb) and a muncie four speed. engine was rebuilt about 3 years ago and has hardly any miles since. truck is pretty solid except for some pitted rust(no holes) around drip rails. also the floorboards have about a 2 inch by 4 inch rust hole on both sides. what do you guys think? im not really planning on seling it, im just curious as to whether i got ripped off in buying it.

11-14-2002, 04:03 AM	#3
bad 71 chevy Registered User Join Date: Jun 2000 Location: Omaha NE 68122 Posts: 637	no ideas but what did you do with the 3 speed and was it on the colom i would love to have the linkages if you still have them if not o well thanks and i woud say no less than 3000 __________________ 71 Chevy C/10 lwb 350 5 speed nv3500 3.73 rear end 2.5" Front Drop and 4" in the back Edelbrock perfomer rpm manifold Edelbrock 600 cfm carb Headmen headers

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-14-2002, 02:03 AM	#2
Lightspeed Registered User Join Date: Oct 2002 Location: Virginia Posts: 226	TTT, anyone have any ideas?

11-14-2002, 06:14 AM	#4
Lightspeed Registered User Join Date: Oct 2002 Location: Virginia Posts: 226	no don't have the linkage. i paid 2600 for her, so i guess i did ok.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.