|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-01-2007, 11:09 PM
|
#1 |
|
Yellow truck club
Join Date: Apr 2006
Location: Barrie Ontario
Posts: 2,080
|
Question for the guys with a Mustang II front end
Just wondering how you folks raise (jack) up the front of your trucks to get under for service. Do you use the MII cross member to raise it or frame one side at a time?
Thanks ...Brian 
__________________
................................................................ Brian ...... My hub garage address http://www.hubgarage.com/mygarage/59apache I gue$$ everything has it'$ price ALL GONE NOW   59 Chev Apache PRAISE THE LOWERED 350 700r lokar shifter power MII front end, shockwaves tilt, 4 wheel discs 4-link and bags 10 bolt limited |
|
|
|
02-02-2007, 12:32 AM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: near Fresno, Ca
Posts: 31
|
Re: Question for the guys with a Mustang II front end
On my 1948 Chevy 5 window, I have a TCI set up. My tire size if 215-60X15. My floor jack is 4 inches high and just will roll under the TCI cross member. This is where I lift the front end
|
|
|
|
|
02-02-2007, 01:17 PM
|
#3 |
|
Registered User
Join Date: Dec 2002
Location: Cactus Patch So. Az
Posts: 4,749
|
Re: Question for the guys with a Mustang II front end
I use the center of the crossmember to jack up the truck, but I have to drive up on a couple of 2X6 to raise the center up high enough to roll the jack under the crossmember!!
__________________
53 TuTone Extended Cab 350 4-Spd 3:08 (SOLD) 53 Chevy Moldy pearl green ZZ-4 4L60E 9" 3:25 55 GMC 1st Black Mll (ZZ4) ZZ6 TKO 600 5 sp 3:73 62 Solidaxle Corvette Roman Red (327 340hp 4spd 3:36) C4 & C5 suspension tube chassis LS 3 4L70E 65 Corvette Coupe 327 350hp 4spd 4:11 78 Black Silverado SWB (350/350) 5.3 & 4L60E 3:42 2000 S-Type 3.0 (wife cruiser) 2003 GMC SCSB 5.3 4L60E 3:42 |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
